1500 mm - 100 mm M125Y structured packing in washing tower
1. 1500mm -100 mm layer height 125Y packing fast delivery
In our workshop, we produce large quantity of M125Y packing every
day. The popular packing layer is 100mm, 150mm, and 200mm in
height. We can make any size and any shape of the 125Y metal plate
packing, as per customer requirement. We are near to the sea port
and the shipping cost is relatively low. If needed, we can add
fasten wires to strengthen the structure.
2. 1500mm -100 mm layer height 125Y packing characteristics
Stainless steel orifice corrugated packing is a number of
corrugated plates pressed from stainless steel strip, which are
vertically stacked and assembled into a disc-shaped structured
packing according to the requirements of a certain diameter. The
corrugations of the adjacent corrugated plates are inclined in the
opposite direction, and the corrugations of the upper and lower
adjacent packing plates are 90 ° crossed.
Before the corrugated plate is pressed, it is necessary to punch
holes on the plate in advance and press the fine grain, or use the
rolling grain equivalent to the fine grain.
Eight types of stainless steel orifice plate corrugated packing are
listed in the table. The characteristic parameters of the type
selection are the specific surface area of the packing and the
angle of the corrugation, which can be selected according to the
process design requirements.
3. 1500mm -100 mm layer height 125Y packing info
| Product | M125Y metal plate structured packing |
| Manufacturer | Metal Wire Mesh Co., Ltd. |
| Material | SS304, SS316L, 410s, etc. |
| Layer height | 100mm, 150mm, 200mm, etc. |
| Shape | Round, Square, Rectangular, Donut, etc. |
| Size | 50mm to any size |
4. 1500mm -100 mm layer height 125Y packing requirements
According to the requirements, punching, rolling fine grain (or
rolling grain equivalent to fine grain) and corrugation of raw
stainless steel belt shall be made into corrugation belt of orifice
plate, and then the corrugation plate shall be cut into pieces
according to different chord length on the cross section of packing
plate and the requirements of packing plate assembly or block
assembly.
The packing plate is composed of a number of corrugated plates
arranged vertically and evenly. The corrugation angle of the two
adjacent orifice plates is overlapped in the opposite direction.
According to the design of tower equipment, the packing plate can
be made into a whole plate or block type. The purpose of block type
is to facilitate the installation of packing. Each block size shall
be able to enter the tower from the manhole for assembly. For
towers with a diameter less than 800mm, they can be manufactured as
a whole tray or into blocks.
The whole disc of packing shall be tightly clamped with steel belt,
and the end of the hoop shall be lapped and spot welded to prevent
the packing from deformation. After the upper hoop is installed,
the upper edge shall be cut and reserved for the flanging before
the packing is installed in the tower, and the hoop shall be made
into the form of anti wall flow ring. For the block packing, the
packing block close to the tower wall shall be made into the form
of anti wall flow ring at the end close to the tower wall. The gap
between the slits depends on the diameter of the tray, and it shall
be close to the tower wall.
5. Stainless steel plate 125Y type structured packing picture
Warmly welcome your inquiry!
