M125Y structured packing layer height 150 mm rectangular shape
1. Stainless steel plate 125Y type structured packing
In our workshop, we produce large quantity of M125Y packing every
day. The popular packing layer is 100mm, 150mm, and 200mm in
height. We can make any size and any shape of the 125Y metal plate
packing, as per customer requirement. We are near to the sea port
and the shipping cost is relatively low. If needed, we can add
fasten wires to strengthen the structure.
2. Stainless steel plate 125Y type structured packing self-distribution
The liquid drips on the filler from the distributor, adheres to the
surface of the filler and flows randomly along the surface, and
some liquid drips from the boundary of the filler. The geometry of
the packing determines the axial and radial velocity of the liquid
flow. The physical quantity that characterizes the radial velocity
is called the radial dispersion coefficient. The results show that
the radial dispersion coefficient (DR) of bulk packing increases
with the increase of packing size. The better the permeability (the
lower the pressure) is, the smaller the DR (i.e. the smaller the
radial mixing degree of liquid) is. At the same time, due to the
non-uniform void fraction, the liquid is easy to gather in the
process of flowing down along the filler to form the gully and
stream. When the dispersion and focusing reach equilibrium, a
stable flow distribution is formed, that is, the natural flow
distribution of this kind of filler. The larger DR is, the smaller
the height of filler required to reach the natural flow
distribution is.
Due to the regular geometry of structured packing, the liquid flows
along a specific channel, the radial dispersion coefficient of
structured packing is much higher than that of bulk packing, and
the flow uniformity of natural flow distribution is also much
higher than that of bulk packing.
3. Stainless steel plate 125Y type structured packing info
| Product | M125Y metal plate structured packing |
| Manufacturer | Metal Wire Mesh Co., Ltd. |
| Material | SS304, SS316L, 410s, etc. |
| Layer height | 100mm, 150mm, 200mm, etc. |
| Shape | Round, Square, Rectangular, Donut, etc. |
| Size | 50mm to any size |
4. Stainless steel plate 125Y type structured packing manufacturing requirements
According to the requirements, punching, rolling fine grain (or
rolling grain equivalent to fine grain) and corrugation of raw
stainless steel belt shall be made into corrugation belt of orifice
plate, and then the corrugation plate shall be cut into pieces
according to different chord length on the cross section of packing
plate and the requirements of packing plate assembly or block
assembly.
The packing plate is composed of a number of corrugated plates
arranged vertically and evenly. The corrugation angle of the two
adjacent orifice plates is overlapped in the opposite direction.
5. Stainless steel plate 125Y type structured packing picture
Warmly welcome your inquiry!
